BRENT'S CARAVANDEPLOYMENT EXPLORER P5.1

INTENDED DESIGN MODEL v09 · NETWORK P4

EXPLORE THE VAN

CONDUCTORS

48 V +24 V +12 V +ReturnDataControl

Interface colours follow JJTD.
Conductor colours identify electrical systems.

Advanced

Cables

Opening your caravan modelLocal model · embedded product artwork

PHYSICAL DEPLOYMENT

One van. Every connection.

Choose a zone, then follow its terminals to the next device.

Drag to look around · wheel to adjust view · overview / area / device navigation

START EXPLORING

Follow the hardware.

Open a physical zone of the van. Select a device to see its labelled connections.

01Choose the rear board, batteries, kitchen or another zone.

02Pick a component and its destination terminal.

03Watch the route, then arrive at the other end.

The model represents intended placement. Cable paths are routing previews; wire sizes, exact pins and unresolved mounting locations remain TBC.

REVISION P5.1

Deployment explorer

This local P5.1 app connects the v09 installation model to electrical revision P4. It preserves P2 IDs, records current intended low-voltage changes, and adds physical terminals, independent lighting and control routes. It has not been published.

Board locations are visual model anchors, not drilling dimensions. The view looks toward the rear: driver side is left and passenger side is right when viewed from inside. Unmodelled equipment and proxy geometry are identified in the inspector.

All cable views and animations use the shared marked highway network. Closest terminal take-offs and the interpreted corridors remain unmeasured. Cable areas, fuse ratings, supplier interfaces and physical pinouts still need verification. The diagram's colours do not specify conductor insulation.

Open preserved P2 PDF